DIY- Make Your Own Tufted HeadboardPosted on 19 Mar 2014
Now, this isn’t a quick afternoon DIY project, but I think the results are well worth it. It took us 2 1/2 days to complete this headboard. I am confident we could make another one much faster but we took our time to figure out the process and not rush through it. The instructions below will help you make your own tufted headboard.What you needMaterials
- 3/4 inch plywood
- 3 inch thick foam – the foam doesn’t have to be this thick but I think it really creates the deep tufted look
- Polyester batting
- Fabric – for my queen size bed I used 3 yards of 54? wide fabric for the headboard and buttons, make sure to buy enough extra fabric to compensate for the tufts
- Spray adhesive
- Circular saw or jigsaw
- Staple gun
- Upholstery needles
- Button kit
- Upholstery twine/thread
- Zip ties – mine were 8 inches long
- Lay out your button pattern on the plywood. We started our first row 2 1/2 inches down from the top of the plywood and spaced the buttons 9 inches apart. Make sure to not get too close to the edge of the plywood with your spacing. Also, for the diamond pattern, you need to alternate your rows – so the next row of buttons will start 4 1/2 inches below and to the side of the first button. Keep in mind that the more buttons you have, the more work it will be – so space out your buttons accordingly (I had a friend do 12 inches in between buttons and it looks great too.) After you have your pattern laid out, drill small holes through the plywood where each button goes. Make sure the holes are big enough to pass through a zip tie and upholstery needle.
- Cut your foam down to size and use the spray adhesive to secure it to the top of your plywood.
- Use your button kit to cover buttons in your fabric. For this step, follow the directions that come with your button kit and make the appropriate amount of buttons for your headboard. Keep in mind that the thicker your fabric is, the harder this will be. I used velvet so this was the hardest step for me!
- Cut your upholstery twine in pieces about 8 inches long and tie in a knot to the back of each button.
- Now it is time to start the tufts, so drape the fabric over the headboard and find a comfortable place to work. I started in the middle of the headboard and worked my way out from there.
- From the back of the headboard, push an upholstery needle through the hole until it starts to come out of the foam on the front side. This is where you will attach your first button.
- With your smallest upholstery needle, thread the button through the fabric in the spot where the needle poked through. Then on the back side of the fabric, securely tie the button through the eye of the zip tie.
- Now tape the end of the zip tie to the upholstery needle and from the back side of the headboard, start pulling the needle slowly through to the back.
- Untape the zip tie from the needle once it comes through the plywood. Using a second zip tie, slip the eye end over the zip tie coming through the headboard – holding the tie in place while you tighten the button from the back
- Before you fully tighten the button, start to work with the fabric on the front of the headboard to get your folding/pleating in place to get the diamond tufted look. The fabric should do this for the most part on its own as you start to form the diamonds, but you may need to adjust the fabric in places to get it to lay right. I got the best results doing this as the button was about halfway tightened and then fully securing the button once I was happy with the fabric.
- Repeat this process, working your way out from the center of the headboard until all tufts are complete. Then wrap the extra fabric around to the back of the headboard and staple it into place.